Search results for query: *

Thanks to Zach at the Dish DIRT team for approving my receiver replacement. Got it in two days. Plugged in the new receiver and within ten minutes all software was downloaded and got live tv. Took about 5 minutes for joey to download its software and it was working as well. Everything is...

Thanks to the help of a knowledgeable forum member and the DIRT team member Zach I think i have done all the steps that would make this receiver work if it wasn't messed up. Here are my steps: 1.Test cables, replace single node box, replace lnb, signal test good on all tuners and satellites...

With the help of one of the member here i can now get it to go to the setup wizard. However, it takes about 10 seconds on software download ( step#3) and never reboots or anything like it got any new software and gives green check mark to say its finished. Tried putting in standby afterwords...

I am not getting the install wizard after a factory default. The unit just basically reboots and then goes back to the channel I was watching. If i reboot hopper hopper startup logo come up and then it goes to television channel. This is WA 110,119,129

I am not sure the unit is really go back to factory defaults. should it remember the last channel it was on if it really went back to factory settings. I will try the steps again tonight and post my results tomorrow

Unit comes up on check switch screen when it is factory reset with the steps you requested. It then completes with a signal error ( i am assuming i was supposed to to leave the sat cable unplugged) it then go to the searching for satellite screen

I will in about an hour when i get home from work. Thanks for the help

after it reboots it goes the last watched tv channel. The tv and guide are working fine. when i installed it it went thought the update software screen but it was pretty quick. if i do a default reset in the menu after it is complete it goes to the channel i was watching. I have soft reset...

I installed a new purchased Hopper and joey a couple of days ago. Followed all of the instructions i found in posts here IE: Let hopper activate and show live tv before connecting joey, etc. Joey connects with hopper via MOCA and both hopper and joey show active MOCA link and can see joey...