Search results for query: *

in apartments it's kind of hard when you can't run any cable on out side of the building or attach anything to building

just tell them to run ground wire to fuse box inside your apartment. after that it is your call if you going to live it there

if you go to guide and pres skip forward several times up to 48 hours ahead does it down load then?

yes

the wire that exposed after you strip it. according to the manual it should be only size of the nickle after you slide connection on but on switches you want to make them longer

if im thinking of right city then you have a major tree problems

you cant just up the elevation to clear the trees. i would say have some one from dish to come out, to verify if you are clearing trees or not and see what your options are

sorry duplicate

i have 1000.2 with DPP 44SW works with no problems. check your connections it sounds like stinger might be a little bit short. also the light have to be on on power supply no mater how it is hocked up

leap frog from radio shack. but doesn't relay work on far distances

not really. but 5 receivers i would re install whole thing and check electoral outlet.

1. it's all depends 2. all you will need is cable from dish to your 301 unless tech ran dual cable from dish to ground.

from satellite dish to your receiver sine box is using power. so if there is short it start to buzz. disconnect SAT cable behind receiver see if it stops

go to menu 6-1-3 then look on left lower corner. it would say TV2 UHF grab the new remote press and hold SAT until all lights are on press the same number on screen then pres pound (#). to match remote addresses

if you hear buzzing it means there is a short some where. trace your cables and check all ends

how old is soft wear on that receiver just do check switch with Sat's hooked up after that cancel out and turn the box of if it need new soft wear it will start the down load with in 2-5 minuets after shutting off

i know that. i was just using as an example to see what type of LNB he has. legacy, DP, or DPP

it has to be DP single or DP dual. legacy will not work

Issue 2: check your component cables, to make sure you didn't cross weirs. usually thats why colors are mest up

it's all depends on the LNB. if you have Dish Pro LNB the test will go any where from 2 of 2 1 to 38. can you tell a little bit more about the LNB? if you have no signal it will tell you no switch detected

any. no

you remote address don't match any more to your receiver. go the menu 6-1-3 grab 6.3 remote press and hold SAT until all lights on then pick a number between 1-15 press pound(#) and then record that should fix it

to me it sounds like low signal on 129. how many transponders have you checked? to determent it is low 60.

get it 950-2100 MHZ. i use Holland or atras spliters

i would say it is not diplexers failing. when you disconnect from sat it re sets LNB so it's starting to work. after a while it goes out. when it happens next time disconnect the cable give it couple of minutes and connect it back see if it is going to come back. you will know it is diplexers or...